Clutch Plate Replacement - Husqvarna CR 125 2011 Workshop Manual

1
4
5
SETTINGS AND ADJUSTMENTS
CR 125 2011 - WR 125 2011

Clutch plate replacement

2
Drain transmission oil as outlined in the relevant paragraph.
- Remove the brake pedal (1).
- Remove the five retaining screws (2) and the clutch cover (3).
- Using an 8 mm wrench, unscrew the five screws (4) securing the clutch
springs. Remove springs, pressure plate (5) with bearing (6) and clutch
actuator plate (7).
- Remove the plates (8), lubricate the new plates with engine oil and install
them (always start with a friction plate).
2
H06677
Refit clutch actuator plate, bearing and pressure plate.
Tighten the spring screws gradually in a cross pattern.
When refitting the clutch cover, check gasket for wear and replace as re-
quired.
For additional information on assembly procedures, see Section "H"
Engine assembly.
7
6
8
8
D.7
H07067
Workshop Manual Ed. 06-2011