1
1
1
2
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013
Clutch disengagement shaft bearing removal
-
Remove the two needle roller bearing using an appropriate tool (1).
H11519
Installation of both clutch disengagement shaft bearings
-
Lightly lubricate both bearings with engine oil.
-
Install the needle roller bearings (1) and (2).
-
Secure the needle roller bearings using an appropriate tool.
2
H11521
Clutch disengagement shaft oil seal installation
-
Lubricate the oil seal lip (1) with engine oil.
-
Install the shaft oil seal (1) using a suitable tool.
-
The open side of the sealing ring must face inward of the casing.
H11520
Disengagement shaft installation
-
Lubricate the clutch disengagement shaft with engine oil.
2
-
Insert the clutch disengagement shaft (1), being careful not to damage the
sealing ring.
-
Install the retaining ring (2).
1
H11522
The top bearing (2) must be aligned with the sealing ring seat.
If the clutch disengagement shaft is installed, cover the notches
with adhesive tape and use an appropriate tool so that the oil seal
is not damaged.
F1.6