Oil Pressure Switch Removal And Installation; Ignition Switch Inspection; Ignition Switch Removal And Installation; Horn Inspection - Suzuki GSF1250 Service Manual

2) Turn the ignition switch ON.
3) Check if the oil pressure indicator (LED) will light up
when grounding the lead wire (1).
If the oil pressure indicator does not light up, replace
the combination meter unit with a new one after
checking the connection of couplers.
1

Oil Pressure Switch Removal and Installation

Refer to "Oil Pressure Switch Removal and Installation in
Section 1E (Page 1E-7)".

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the right frame head cover. (GSF1250/A)
Refer to "Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)".
2) Disconnect the ignition switch coupler (1).
I718H1930036-02
B718H19306024
B718H19306025
1
I718H1930026-05
Combination Meter / Fuel Meter / Horn:
3) Inspect the ignition switch for continuity with a tester.
If any abnormality is found, replace the ignition
switch with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
B/R B/O
Position
ON
OFF
LOCK
P
4) After finishing the ignition switch inspection, reinstall
the removed parts.

Ignition Switch Removal and Installation

Refer to "Ignition Switch Removal and Installation in
Section 1H (Page 1H-9)".

Horn Inspection

NOTE
If the horn sound condition is normal, it is not
necessary to inspect the horn button
continuity.
Horn Button Inspection
1) Remove the right frame head cover. (GSF1250/A)
Refer to "Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)".
2) Disconnect the left handlebar switch coupler (1).
1
9C-10
G/B B/W B/G Br/B
I649G1180025-02
B718H19306026
B718H19306027
I718H1930045-01