3) While the DTCs are being output, set the special tool
to OFF.
CAUTION
!
The DTC deletion mode starts 12.5 seconds
after the switch is set to OFF.
DTC indication
ABS indicator
light
Mode select switch
5) After deleting the DTCs, repeat the code output
procedure and make sure that no DTCs remain (the
ABS indicator light no longer flashes).
NOTE
If any DTCs remain, perform the appropriate
procedures, then delete the codes. If DTCs
are left stored, confusion may occur and
unnecessary repairs may be made.
6) Disconnect the mode select switch and install the left
frame cover.
I718H1450050-01
DTC Deleting Diagram
Permitted range of
erasing DTC
ON
OFF
OFF
ON
1 sec.
1 sec.
1 sec.
4) In the DTC deletion mode, switch the ABS test
switch from OFF to ON three times, each time
leaving it at ON for more than 1 second.
Cleaning complete
1 sec.
0.4 sec. each
0.4 sec. each
0.4 sec. each
Cleaning
start
Indicate signal
"Cleaning complete"
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
7) Afterwards, ride the motorcycle at more than 30 km/
h (18.6 mile/h) and quickly apply the brakes to check
that the ABS activates correctly.
ABS:
4E-26
I718H1450051-01
I718H1450052-01
I718H1450053-01