Suzuki GSF1250 Service Manual page 11

Continuity check
1) Measure resistance across coupler "B" (between "A"
and "C" in figure).
If no continuity is indicated (infinity or over limit), the
circuit is open between terminals "A" and "C".
"A"
2) Disconnect the coupler "B" and measure resistance
between couplers "A" and "B-1".
If no continuity is indicated, the circuit is open
between couplers "A" and "B-1". If continuity is
indicated, there is an open circuit between couplers
"B-2" and "C" or an abnormality in coupler "B-2" or
coupler "C".
"A"
Voltage check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
1) With all connectors/couplers connected and voltage
applied to the circuit being checked, measure
voltage between each terminal and body ground.
2) If measurements were taken as shown in the figure
and results were listed in the following, it means that
the circuit is open between terminals "A" and "B".
Voltage between
"A" and body ground: Approx. 5 V
"B" and body ground: Approx. 5 V
"C" and body ground: 0 V
"B"
ECM
"C"
I705H1000006-02
"B-2"
ECM
"C"
"B"
"B-1"
I705H1000010-02
3) Also, if measured values are as listed following, a
resistance (abnormality) exists which causes the
voltage drop in the circuit between terminals "A" and
"B".
Voltage between
"A" and body ground: Approx. 5 V
"B" and body ground: Approx. 5 V – 2 V voltage
drop
"C" and body ground: 3 V – 2 V voltage drop
0V
"A"
Short circuit check (Wire harness to ground)
1) Disconnect the negative (–) cable from the battery.
2) Disconnect the connectors/couplers at both ends of
the circuit to be checked.
NOTE
If the circuit to be checked branches to other
parts as shown, disconnect all connectors/
couplers of those parts. Otherwise, diagnosis
will be wrong.
Precautions:
"A"
ECM
"B"
"C"
5V
5V
5V
"B" "C"
I705H1000007-01
00-6