4E-25 ABS:
1) Remove the right frame cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-6)".
2) Set up the SDS tool. (Refer to the SDS operation
manual for further details.)
Special tool
(A): 09904–41010 (SDS set)
(B): 99565–01010–010 (CD-ROM Ver.10)
(A)
I718H1450047-01
(A)
(B)
I705H1110116-03
3) Read the DTC (Diagnostic Trouble Code) and show
data when trouble (displaying data at the time of
DTC) according to instructions displayed on SDS.
NOTE
• Not only is SDS used for detecting
Diagnostic Trouble Codes but also for
reproducing and checking on screen the
failure condition as described by
customers using the trigger.
• How to use trigger. (Refer to the SDS
operation manual for further details.)
4) Close the SDS tool and turn the ignition switch OFF.
DTC (Diagnostic Trouble Code) Deleting
Use of Mode Select Switch
1) Remove the left frame cover. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
6)".
2) Connect the special tool to the mode select coupler
(O – B/W) and output the DTCs.
Special tool
(A): 09930–82710 (Mode select switch)
(A)
B718H14504022
I718H1450049-02
I718H1450045-02