Suzuki GSF1250 Service Manual page 642

9A-9 Wiring Systems:
10
13
14
"B"
15
1. Clamp
: Clamp the speed sensor lead wire and HO2 sensor lead wire.
2. Side-stand switch
3. HO2 sensor coupler
4. ABS control unit/HU bracket (GSF1250A/SA only)
: Do not contact the ABS unit wiring harness with the bracket.
5. Frame
6. Wiring harness (GSF1250/A)
7. Wiring harness (GSF1250S/SA)
8. ICES Canada label (E-28 only)
9. Clamp
: Clamp the lead wire at the white marking.
10. Clamp
: Clamp the speed meter lead wire and turn signal lead wires.
11. Wiring harness
[A]
9
11
[B]
12
16
12. Turn signal lead wire (RH)
13. Turn signal lead wire (LH)
14. Clamp
15. Clamp
16. Clamp
"A": Pass the regulator/rectifier lead wire behind hose.
"B": Set the generator lead wire between starter motor and sprocket inner
"a": 20 ± 5 mm (0.8 ± 0.2 in)
[A]: For GSF1250/GSF1250A
[B]: For GSF1250S/GSF1250SA
"a "
8
7
1
3
"A"
: Clamp the regulator/rectifier lead wire and generator lead wire.
: Clamp the speed sensor lead wire, HO2 sensor lead wire and side-
stand switch lead wire.
: Clamp the lead wire inside of clutch hose.
cover.
: 14 N⋅m (1.4 kgf-m, 10.0 lb-ft)
6
5
4
(a)
2
I718H1910916-01