Clutch Hose Removal And Installation - Suzuki GSF1250 Service Manual

5C-5 Clutch:
6) Connect a clear hose to the air bleeder valve and
insert the other end of hose into a receptacle.
7) Loosen the air bleeder valve and pump the clutch
lever until old clutch fluid flows out of the bleeder
system.
8) Close the air bleeder valve and disconnect a clear
hose.
Tightening torque
Air bleeder valve (Clutch) (a): 6 N·m (0.6 kgf-m,
4.5 lb-ft)
(a)
9) Fill the reservoir with new fluid to the upper mark of
the reservoir.
10) Reinstall the removed parts.

Clutch Hose Removal and Installation

Removal
1) Drain clutch fluid. Refer to "Clutch Fluid
Replacement (Page 5C-4)".
2) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
3) Remove the left frame cover and engine sprocket
outer cover. Refer to "Exterior Parts Removal and
Installation in Section 9D (Page 9D-6)" and "Engine
Sprocket Removal and Installation in Section 3A
(Page 3A-2)".
4) Remove the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
I718H1530009-01
Diagram (Page 5C-2)".
Installation
1) Install the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
Diagram (Page 5C-2)".
2) Bleed air from the clutch system. Refer to "Air
Bleeding from Clutch Fluid Circuit (Page 5C-4)".
3) Reinstall the removed parts.
I718H1530010-01
I718H1530015-01
B718H15306006