Suzuki GSF1250 Service Manual page 406

2C-8 Rear Suspension:
5) Remove the pivot shaft end caps (4), left and right.
6) Remove the swingarm by removing the pivot shaft
nut (5) and washer.
4
7) Remove the chain buffer (6).
8) Remove the cushion rods (7).
9) Remove the plates (8).
8
5
I718H1230020-01
6
I718H1230021-02
7
I718H1230022-01
I718H1230023-01
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily the cushion rod mounting nut.
NOTE
The stamped marks "A" on the cushion rod
should be face out side.
• Install the washer and swingarm pivot nut.
• Tighten the swingarm pivot nut to the specified torque.
Tightening torque
Swingarm pivot nut (a): 100 N·m (10.0 kgf-m, 72.5
lb-ft)
"A"
I718H1230024-04
(a)
I718H1230025-02