6B-9 Steering / Handlebar:
Handlebars
• Tighten the handlebar holder set nuts to the specified
torque.
Tightening torque
Handlebar holder set nut (a): 45 N·m (4.5 kgf-m,
32.5 lb-ft)
Inspection after installation
• Check the steering tension. Refer to "Steering Tension
Adjustment (Page 6B-10)".
Steering Related Parts Inspection
Refer to "Steering Removal and Installation (Page 6B-
6)".
Inspect the removed parts for the following
abnormalities.
• Distortion of the steering stem
• Bearing wear or damage
• Abnormal bearing noise
• Race wear or damage
• Bearing lower seal damage
• Rubber seat and damper bushing wear or damage
(a)
I718H1620035-04
B718H16206011
If any abnormal points are found, replace defective parts
with new ones.
Steering System Inspection
Refer to "Steering System Inspection in Section 0B
(Page 0B-20)".
Steering Stem Bearing Removal and Installation
Removal
1) Remove the steering stem lower bracket. Refer to
"Steering Removal and Installation (Page 6B-6)".
2) Remove the dust seal (1) and steering stem upper
bearing (2).
1
I718H1620026-02
I718H1620042-04
B718H16206012
B718H16206008
2
I718H1620039-02