1J-6 Charging System:
12) Remove the generator stator (10) along with the
CKP sensor (11).
11
Installation
Install the generator in the reverse order of removal. Pay
attention to the following points:
• Tighten the generator starter set bolts and CKP
sensor mounting bolts to the specified torque.
NOTE
Be sure the grommet (1) is set to the
generator cover.
Tightening torque
Generator stator set bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
CKP sensor mounting bolt (b): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
1
(b)
(a)
• Degrease the tapered portion "A" of generator rotor
• Fit the key (2) in the key slot on the crankshaft.
• Install the generator rotor onto crankshaft.
10
I718H11A0016-02
• Hold the generator rotor with the special tool and
• Apply molybdenum oil solution to the idle gear shaft
I718H11A0017-01
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely dry.
"A"
tighten its bolt to the specified torque.
Special tool
(A): 09930–44530 (Rotor holder)
Tightening torque
Generator rotor bolt (a): 120 N·m (12.0 kgf-m, 87.0
lb-ft)
(a)
holes.
2
"B"
I718H11A0018-01
(A)
I718H11A0019-01
I718H11A0020-01