Suzuki GSF1250 Service Manual page 225

• Tighten the speed sensor rotor bolt to the specified torque.
Tightening torque
Speed sensor rotor bolt (h): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• Before installing the engine sprocket inner cover, apply a small quantity of SUZUKI SUPER GREASE to the clutch
push rod.
: Grease 99000–25010 (SUZUKI SUPER GREASE A or equivalent)
• Install the engine sprocket inner cover. Refer to "Engine Sprocket Removal and Installation in Section 3A (Page 3A-
2)".
• Install the gearshift link arm to the gearshift shaft in the correct position.
Gearshift lever height "d"
Standard: 45 – 55 mm (1.8 – 2.2 in)
• Install the exhaust pipe assembly and muffler. Refer to "Exhaust Pipe / Muffler Removal and Installation in Section
1K (Page 1K-3)".
• Install the radiator. Refer to "Radiator / Cooling Fan Motor Removal and Installation in Section 1F (Page 1F-5)".
• Install the throttle body. Refer to "Throttle Body Removal and Installation (Page 1D-9)".
• After remounting the engine, route the wiring harness, cable and hoses properly. Refer to "Wiring Harness Routing
Diagram in Section 9A (Page 9A-8)", "Throttle Cable Routing Diagram (Page 1D-2)" and "Water Hose Routing
Diagram in Section 1F (Page 1F-3)".
• Pour engine coolant and engine oil. Refer to "Cooling System Inspection in Section 0B (Page 0B-12)" and "Engine
Oil and Filter Replacement in Section 0B (Page 0B-10)".
• After finishing the engine installation, check the following items.
– Throttle cable play
Refer to "Throttle Cable Play Inspection and Adjustment in Section 0B (Page 0B-12)".
– Throttle valve synchronization
Refer to "Throttle Valve Synchronization (Page 1D-15)".
– Drive chain slack
Refer to "Drive Chain Inspection and Adjustment in Section 0B (Page 0B-15)".
– Engine oil and coolant leakage
Refer to "Cooling Circuit Inspection in Section 1F (Page 1F-4)".
(h)
I718H1140377-01
"a"
I718H1140378-01
Engine Mechanical: 1D-23