Suzuki GSF1250 Service Manual page 441

10) Loosen the rear axle nut (8).
11) Loosen the chain adjusters (9) to provide additional
chain slack.
9
12) Remove the engine sprocket (10).
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Apply THREAD LOCK SUPER to the driveshaft.
: Thread lock cement 99000–32030 (Thread
Lock Cement Super 1303 or equivalent)
• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 115 N·m (11.5 kgf-m, 83.0
lb-ft)
8
I718H1310023-05
10
I718H1310008-02
1
(a)
I718H1310035-02
Drive Chain / Drive Train / Drive Shaft:
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
• Before installing the engine sprocket inner cover,
apply a small quantity of SUZUKI SUPER GREASE to
the clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket inner cover (3).
NOTE
Fit the clamp to the bolt "A".
• Tighten the speed sensor mounting bolt (4) to the
specified torque.
Tightening torque
Speed sensor bolt (c): 6.5 N·m (0.65 kgf-m, 4.7 lb-
ft)
"A"
3A-3
2
(b)
I718H1310010-02
4
(C)
3
I718H1310024-02