Suzuki GSF1250 Service Manual page 100

1A-31 Engine General Information and Diagnosis:
Step
2 4) Disconnect the IAP sensor (No.1) coupler.
5) Check the continuity between the B wire and W/Bl wire.
If the sound is not heard from the tester, the circuit
condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
6) Disconnect the ECM coupler. Refer to "ECM Removal
and Installation in Section 1C (Page 1C-1)".
7) Insert the needle pointed probes to the lead wire coupler.
8) Check the continuity between the W/Bl wire "C" and
terminal "26".
If OK, then check the continuity between the B/Br wire
"B" and terminal "29".
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe set)
Tester knob indication
Continuity test (
"C"
(B)
"26"
Is the continuity OK?
Action
)
(A)
)
"B"
"29"
Yes
Go to Step 4.
I718H1110259-01
(A) )
I718H1110024-03
No
W/Bl wire shorted to
Vcc, or B/Br wire open.