Handlebars Inspection - Suzuki GSF1250 Service Manual

• Apply SUZUKI SUPER GREASE to the end of the
throttle cables and cable pulley.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Insert the projection "C" of the right handlebar switch
box into the hole of the handlebars.
• Install the front brake master cylinder. Refer to "Front
Brake Master Cylinder Assembly Removal and
Installation in Section 4A (Page 4A-14)".
• Apply a handle grip bond "D" onto the left handlebar
before installing the handlebar grip.
: Handle grip bond (Handle Grip Bond
(commercially available))
"D"
• Insert the projection "E" of the left handlebar switch
box into the hole of the handlebars.
• Install the clutch master cylinder. Refer to "Clutch
Master Cylinder Assembly Removal and Installation in
"C"
Section 5C (Page 5C-7)".
• After installing the steering, the following adjustments
I718H1620006-02
are required before driving.
– Cable routing (Refer to "Throttle Cable Routing
Diagram in Section 1D (Page 1D-2)".)
– Throttle cable play (Refer to "Throttle Cable Play
Inspection and Adjustment in Section 0B (Page 0B-
12)".)

Handlebars Inspection

Refer to "Handlebar Removal and Installation (Page 6B-
3)".
Inspect the handlebars for distortion and damage.
If any defect is found, replace the handlebars with a new
one.
I649G1620008-03
Steering / Handlebar:
"E"
I718H1620007-04
B718H16206003
I649G1620010-03
6B-4