Rear Turn Signal Light Removal And Installation; Turn Signal Light Bulb Replacement; Reflex Refractor Construction - Suzuki GSF1250 Service Manual

9B-10 Lighting Systems:

Rear Turn Signal Light Removal and Installation

Removal
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-6)".
2) Remove the tool set (1) and disconnect the turn
signal light coupler (RH: Black, LH: Gray) (2).
1
3) Remove the turn signal light (3) by removing the nut.
Installation
Install the rear turn signal light in the reverse order of
removal.

Reflex Refractor Construction

1
(a)
1. Front reflex refractor (For E-03, 24, 28, 33)
2. Front fork
B718H19206014
2
I718H1920028-01
3
I718H1920029-02
(b)
2
3. Rear reflex refractor (For E-03, 28, 33)
4. Rear fender

Turn Signal Light Bulb Replacement

CAUTION
!
When you touch the bulb with your bare
hands, clean the bulb with a cloth moistened
with alcohol or soap water to prevent
premature bulb failure.
1) Remove the lens by removing the screw.
2) Replace the bulb (1).
1
3) Reinstall the lens.
(a)
3
B718H19206015
I718H1920030-01
I718H1920031-01
B718H19206016
4
I718H1920044-05
: 1.8 N⋅m (0.18 kgf-m, 1.3 lb-ft)
: 4.5 N⋅m (0.45 kgf-m, 3.25 lb-ft)