Suzuki GSF1250 Service Manual page 50

0B-19 Maintenance and Lubrication:
Air Bleeding from Brake Fluid Circuit
Refer to "Air Bleeding from Brake Fluid Circuit in Section
4A (Page 4A-8)".
Rear Brake Light Switch Adjustment
Refer to "Rear Brake Light Switch Inspection and
Adjustment in Section 4A (Page 4A-8)".
Tire Inspection
Inspect tire
Every 6 000 km (4 000 miles, 12 months)
Tire Tread Condition
Operating the motorcycle with excessively worn tires will
decrease riding stability and consequently invite a
dangerous situation. It is highly recommended to replace
a tire when the remaining depth of tire tread reaches the
following specification.
Special tool
: 09900–20805 (Tire depth gauge)
Tire tread depth (Service limit)
Front: 1.6 mm (0.06 in.)
Rear: 2.0 mm (0.08 in.)
Tire Pressure
If the tire pressure is too high or too low, steering will be
adversely affected and tire wear increased. Therefore,
maintain the correct tire pressure for good roadability or
shorter tire life will result. Cold inflation tire pressure is as
follows.
Cold inflation tire pressure
B718H10206024
Front
Rear
CAUTION
!
The standard tire fitted on this motorcycle is
120/70 ZR17 M/C (58W) for front and 180/55
ZR17 M/C (73W) for rear. The use of tires
other than those specified may cause
instability. It is highly recommended to use
the specified tires.
Tire type
DUNLOP
• Front: D218FT
I310G1020068-02
• Rear: D218N
Solo riding
kPa kgf/cm 2 psi kPa kgf/cm
250 2.50 36 250
290 2.90 42 290
Dual riding
2 psi
2.50 36
2.90 42
I310G1020069-02