Step Mode: A Cli Configuration Technique; Validating Your Configuration - Motorola Netopia 7000 Administrator's Handbook

Step Mode: A CLI Configuration Technique
The Motorola Netopia® Gateway command line interface includes a step mode to automate the pro-
cess of entering configuration settings. When you use the CONFIG step mode, the command line inter-
face prompts you for all required and optional information. You can then enter the configuration values
appropriate for your site without having to enter complete CLI commands.
When you are in step mode, the command line interface prompts you to enter required and optional
settings. If a setting has a default value or a current setting, the command line interface displays the
default value for the command in parentheses. If a command has a limited number of acceptable val-
ues, those values are presented in brackets, with each value separated by a vertical line. For example,
the following CLI step command indicates that the default value is
on off
ited to and .
option (off) [on | off]:
You can accept the default value for a field by pressing the Return key. To use a different value, enter it
and press Return.
You can enter the CONFIG step mode by entering
can enter step mode for a particular service by entering
(press Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>> set system
...
system
name ("Netopia-3000/9437188"): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
validate
You can use the
been entered correctly. If you use the
that all required settings for all services are present and that settings are consistent.
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
validate
You can use the
Netopia® Gateway automatically validates your configuration any time you save a modified configura-
tion.
set
CONFIG command to make sure that your configuration settings have
validate
command, the Motorola Netopia® Gateway verifies
command to verify your configuration settings at any time. Your Motorola
off
and that valid entries are lim-
on
from the top node of the CONFIG hierarchy. You
set
service_name
.
In stepping set mode
147