Installation; Preparation; Installation Procedure - Motorola PTP 600 Series User Manual

7 Installation

IMPORTANT Motorola recommends that only qualified personnel undertake the installation of
a PTP 600 Series Bridge solution.
We recommend that the practices and procedures detailed in the Motorola manual R56
"STANDARDS AND GUIDELINES FOR COMMUNICATION SITES" (68P81089E50) be
applied to all new site build activities. For a copy of the manual please see your local
Motorola representative. The manual can be downloaded from the Motorola Intranet site
http://compass.mot.com/go/190860869.
7.1

Preparation

Before proceeding with the installation you should:
x
Check the contents of all packages against the parts lists shown in the packing list.
x
Ensure that you have the correct tools for the job.
x
Ensure that you are qualified to undertake the work.
x
Ensure that you have taken the correct safety precautions.
x
Have completed the site planning as described in Section 6 "Site Planning".
7.2

Installation Procedure

The 600 Series installation procedure consists of the following steps:
x
Mounting the ODUs, Section 7.6 "Mounting the ODU
x
Connecting up, Section 7.7 "Connecting Up"
x
Mounting the PIDU Plus units, Section 7.7.9 "Mounting the PTP 600 Series Bridge PIDU
Plus"
x
Mounting the Lightning Protection Units, Section 10.2 "Detailed Installation".
x
Mounting the GPS Sync Unit (if required), Section 14 "TDD Synchronization
Configuration and Installation Guide" and refer to the "GPS Sync Unit Kit" User Manual
available in your installation CD for specific information related to the GPS Sync Unit.
x
Powering Up, Section 7.7.10 "Powering Up".
x
Aligning the ODUs, Section 7.7.11 "Aligning the PTP 600 Series Bridge ODUs".
"
s
99
7 Installation