Restoring The System - Digital Equipment 300 Series AXP Reference Manual

Restoring the System

After you have installed all the internal options you want to
Save the Wrist
Strap install at this time, or have completed maintenance, remove and
save the antistatic wrist strap as follows:
Step
1
2
3
4
Replace the To replace the system cover, see Figure 2–31 and follow these
System Unit steps:
Cover
Step
1
2
3
4
Action
Remove the copper end of the strap from the system unit.
Cover the sticky surface with the protective paper you
removed earlier.
Unwrap the strap from your wrist.
Refold the strap and save it in the envelope it came in for
future use.
Action
Align the lip on the front inside edge of the cover
the four tabs along the front edge of the system unit
Position the cover so that the lip fits over the tabs.
Maintain a slight pressure on the front of the cover
you lower it.
Be sure the sides of the cover fit over the outside of the
bottom enclosure.
Press down firmly on the edges of the cover.
Replace the two screws on the back of the system unit
that hold the cover in place
Restoring the System
with
.
.
as
2–55