System Personalization Capabilities - Digital Equipment 300 Series AXP Reference Manual

System Personalization Capabilities

Firmware Your system firmware includes commands and parameters that
Parameters you can change to suit your specific needs. You may change the
default settings for these parameters from console mode (>>>) by
entering the
to change, as described in the next table.
To change this...
The action the console takes after a halt
The default boot device
The default diagnostic startup mode
Refer to Chapter 4 for the format and available settings for these
parameters.
Before You Do not change any parameters without fully understanding the
Change effect that the change may have on your workstation. If you are
Parameters not sure about changing parameters, ask your system manager
for assistance, or your Digital service representative.
System Personalization Capabilities
command followed by the parameter you want
set
Use this command...
set auto_action
bootdef_dev
set
diag_quick
set
1–13