Digital Equipment 300 Series AXP Reference Manual page 92

Restoring the System
Step
2
3
4
Record If any messages are displayed, write them down in case you need
Messages to contact your Digital service representative.
If you see error messages during the startup or
procedure, check the following:
•
•
•
•
If gaining entry to the system unit is required for checking
cables and modules, refer back to the section entitled Preparing
Your System.
If you continue to see error messages, refer to Chapter 7 or
Chapter 8, or contact your Digital service representative.
2–60
Action
Enter the
show device
display a list of the devices in your system. If you have a
DEC 3000 Model 300/300X/300LX system, this command
will also display a list of your TURBOchannel modules.
Enter the
show mem
to verify that installation of additional memory was
successful.
At the console prompt (>>>), enter the
command.
boot
If your system has the OpenVMS AXP or the DEC OSF/1
AXP operating system software already installed, enter
B at the console prompt, and press the Return key to
automatically start your system. If you do not already
have operating system software, refer to your software
documentation.
Are all cables inside and outside the system properly
connected?
Are all modules fully seated in their connectors?
Are SCSI switches and jumpers set correctly? (No two
devices should have the same SCSI ID setting.)
Are any SCSI ID addresses set to ID 7? The system SCSI
controller uses SCSI ID address number 7.
command at the console prompt to
command at the console prompt
set auto_action
show config