Digital Equipment 300 Series AXP Reference Manual page 49

Remove the
System Unit
Cover
To remove the system unit cover, refer to Figure 2–6 and follow
these steps:
Step Action
1 Remove the two Phillips screws on the right and left back
corners of the system unit cover
2 Place the system unit so that the back edge extends over
the edge of your table or desk.
3 Place your thumbs on the two black caps
the system unit, and at the same time, place your fingers
under the cover's bottom edge. Press down with your
thumbs while you press up against the cover's edge with
your fingers to lift the cover.
A significant amount of pressure is required to lift the
cover. You may want to cushion your fingers.
4 Pivot the cover on the tabs that run along the system
unit's front edge.
5 Pull the system unit cover up and away until it releases
from the tabs.
6 Place the cover safely aside.
Preparing Your System
.
on the back of
Note
2–17