Cabling A Drive In Position - Digital Equipment 300 Series AXP Reference Manual

Removing and Installing a Fixed Disk Drive
To cable the drive that you are installing in position 1, follow
Cabling for
Drive in these steps and refer to Figure 2–17:
Position 1
Step
1
2
3
Figure 2–17 Cabling a Drive in Position 1
2–30
Action
Connect the large power connector
to the power port on the back of the RZxx drive.
Connect the internal SCSI cable
drive. Be sure the key (the notch in the center of the
cable connector) is facing up. The power cable
under the SCSI cable.
Lay the terminator, located at the end of the SCSI cable,
and the remaining length of power cable in the empty
position 2.
2
3
on the power cable
to the back of the disk
must be
1
MLO-010660