System Display After Restoring Your System - Digital Equipment 300 Series AXP Reference Manual

Figure 2–33 System Display After Restoring Your System
DEC 3000 - M300
Digital Equipment Corporation
System conducting power up tests
-----------------------------------------------------
DEVNAM
-------
-----------------------------------------------------
System power up OK.
>>>
Test the System To confirm that the options are connected correctly:
Step
1
DEVSTAT
-------
CPU OK KN16-AA - Vx.x-Syyy-Izzz - sx.x - DECchip 21064 P3.0
ASIC OK
MEM OK 32MB
NVR OK
CXT OK
SCC OK ptr(0) = Present keybd(2) = Present
NI OK Ethernet Address: 08-00-2B-2F-F8-E6 , TENBT
SCSI OK
ISDN OK
Action
Enter the
show device
to display the status of the drives, as explained in the
section entitled Recording Information Before Making
Changes at the beginning of this chapter.
From this display, you can:
• Compare the new display with the display you viewed
when you prepared the system. You should see the
new drive, and the drive that was in the system before
you made the addition. If the new drive is not in the
list, it has not been installed properly.
• Verify that devices are set to the correct SCSI settings
(ADDR) so that all devices can be accessed.
• Verify that there are no error messages. If there are
error messages, write them down. See Chapter 8.
Restoring the System
command at the console prompt
2–59