Digital Equipment 300 Series AXP Reference Manual page 151

The following example shows the mode selected.
>>> sh diag_s
Result:
DIAG_SECTION = 2
Example: show To execute the
enable_audit syntax:
Command
>>> sh[ow] enable_a[udit]
The following example shows the boot audit trail enabled.
>>> sh enable_a
Result:
ENABLE_AUDIT = ON
Example: show To execute the
error Command
>>> sh[ow] e[rror]
The following example displays the error information.
>>> show error
Result:
??002 SCC 0x0040
?T-ERR-SCC-MODEM - CTS bit Exp = 1 Rec = 0
The status message in this example means that the modem test
expected the CTS bit to be set, but it was clear.
??001 SCC 0x0060
?T-ERR-SCC-Mouse - %x char recvd
The status message in this example means that the response
received from the mouse was less than the number of characters
expected.
Return
enable_audit command, use the following
show
Return
Return
show error command, use the following syntax:
Return
Return
SHOW
4–53