Removing The Cpu Module - Digital Equipment 300 Series AXP Reference Manual

Figure 2–25 Removing the CPU Module
Install the CPU To install the CPU module, reverse all steps in the removal
Module procedure and refer to Figure 2–25, as follows:
Step
1
2
3
Removing and Installing the CPU Module
1
2
Action
Be sure the system preparation task are complete. See
the section entitled Preparing Your System for more
information.
Holding the module by its edges, set it onto the four posts
to which it attaches . (Do not handle the module by the
aluminum heat sink .) Push down on the connector end
of the module to ensure a good connection.
Tighten the four captive screws to the posts: two at the
back corner edges of the module, and two at the center
edges.
2
MLO-009788
2–45