Removing And Installing The Power Supply - Digital Equipment 300 Series AXP Reference Manual

Removing and Installing the Power Supply

Removing and Installing the Power Supply
Antistatic Do not remove or install any internal option without attaching
Precautions the antistatic wrist strap to your wrist and the system. Refer to
the section entitled CAUTION: Static Discharge earlier in this
chapter.
Remove the To remove the power supply, refer to figures 2–26 and 2–27, and
Power supply perform the following steps:
Step
1
2
2–46
Action
Be sure the system preparation tasks are complete. See
the section entitled Preparing Your System for more
information.
Squeeze the plastic tab on the front of the power supply
cable connector and pull up to disconnect the cable from
the system module. See Figure 2–26.
If any drives are installed, disconnect the cable from these
drives as well.