Digital Equipment 300 Series AXP Reference Manual page 86

Removing and Installing the System Module
Install the To install the system module, reverse all steps in the removal
System Module procedure and refer to Figure 2–30, as follows:
Step
1
2
3
4
5
6
7
8
9
10
11
12
2–54
Action
Be sure the system preparation tasks are complete. See
the section entitled Preparing Your System for more
information.
Insert the connectors on the system module through
the openings on the bottom enclosure. Seat the system
module over the standoffs
Add the two screws labeled
Screw the four TURBOchannel posts in place, see
Figure 2–30.
Add the four CPU module support posts, see
Figure 2–25.
Install the memory modules (SIMMs), see Figure 2–22.
Install the drive(s). Refer to the sections entitled
Removing and Installing a Removable-Media Drive and
Removing and Installing a Fixed Disk Drive.
Install the CPU module. Refer to the section entitled
Install the CPU Module.
Install the power supply. Refer to the previous section
entitled Install the Power Supply.
Connect the power cable and the internal SCSI cable to
the system module and the drives. See Figure 2–26.
Install the TURBOchannel modules and/or the option slot
filler plates. See figures 2–23 and 2–24.
Connect all cables to the back of the system unit.
and push down gently.
in Figure 2–30.
in
in