Digital Equipment 300 Series AXP Reference Manual page 180

Invoking the Password Security Feature
If the two passwords you enter do not match, the console displays
the following error message:
? 30 ILL PSWD
In this case, enter the
above.
Note Your Be sure to make a note of your password and store it in a secure
Password place. If you forget your console mode password, refer to Erase
The Password, later in this chapter, or call your Digital service
representative.
Enable the Once you have entered and confirmed your password, check to be
Password sure the secure parameter is set to on, as follows:
Security
>>> show secure
Feature
SECURE = OFF
If, as in the example above, the password security feature is not
enabled, set it to on, as follows:
>>> set secure on
SECURE = ON
Before You After entering a password and enabling the secure parameter,
Move the you must move the secure system jumper, on the system module,
Secure System to the enable position to complete the security feature.
Jumper
Before you move the secure system jumper, be sure you complete
the following steps:
Step
1
2
3
4
5–4
set password
Return
Return
Action
Halt the system, if necessary, to display the console
prompt (>>>). (See Chapter 2.)
Turn off your equipment. (See Chapter 2.)
Remove the system unit cover. (See Figure 2–6).
Attach the antistatic wrist strap.
command again as described