Changing, Erasing, and Disabling the Password
Once your password is erased, you can enter a new password as
explained in the section Enter a New Password earlier in this
chapter.
Disable the
To disable the password security feature, you must enter the
Password
login
command at the console prompt:
>>> set secure 0
SECURE = OFF
If you then try to log in, the following message is displayed:
?31 PASWD NOTEN
5–8
When you turn on the system, the firmware is loaded
into and executed from memory. If you did not disable
the flash ROM update jumper, be aware that using
the
command to place a value in a location of
deposit
memory containing the actual console firmware could
hang the system. To restart the system, turn the power
off and than back on.
command and your password. Then enter the following
Return
Caution