Cabling The Rx26 Drive - Digital Equipment 300 Series AXP Reference Manual

Removing and Installing a Removable-Media Drive
Step
3
4
Figure 2–14 Cabling the RX26 Drive
Install a To install a removable-media drive, reverse the steps in the
Removable-Media removal procedure as follows:
Drive
Step
1
2
3
2–26
Action
Connect the internal SCSI cable with the key facing up
to the SCSI port on the back of the drive. The power
cable must be under the SCSI cable.
Tuck the SCSI terminator
SCSI cable, in the mounting bracket under the RX26
drive.
2
Action
Record the SCSI ID setting for future use. Refer to
Chapter 4, the
show device
Be sure all system preparation tasks are complete. See
the section entitled Preparing Your System.
Be sure the cables are all connected.
, located at the end of the
3
1
MLO-009745
command.
4