Cpu Module And Atm Module Locations; Cpu Module And Atm Module Removal Procedure - Digital Equipment VAXft Systems 810 Service Information

5.4.1 CPU and ATM Modules
You use the same steps to remove the CPU and ATM modules. Figure 5–2 shows
the locations of the modules. Table 5–3 describes the removal procedure.
Figure 5–2 CPU Module and ATM Module Locations
Table 5–3 CPU Module and ATM Module Removal Procedure
Step
1
2
3
4
Captive
Screws
Module
Release
Levers
ATM
Module
CPU
Module
CPU Cabinet
MR−0435−92RAGS
Action
Ask the operator or system manager to shut down the zone using the procedure
in Section 5.3.2.
Open the front door of the cabinet.
Loosen the captive screws on the module. The CPU module has four captive
screws; the ATM module has two captive screws.
Open the module release levers and slide the module out.
Error Handling and Analysis 5–7