Remove The Ac Line Filters; 110V Ac Line Filter - Christie CP2215 Service Manual

Parts and Module Replacement

Remove the AC Line Filters

The AC line filters and A/C selector switch are located at the rear-left corner of the projector.
• The 110V filter is for the optional UPS hookup. Use the UPS to keep the projector's electronics
powered ON in the event of a power loss so that the lamp can be struck as soon as full power is
reapplied without having to wait for the electronics to restart.
• The 220V filter is required to power the LPS and strike the lamp.
• The A/C selector switch is used to select between the 110V and 220V power source.

110V AC Line Filter

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lamp. See
4. Remove the exhaust panel and rear projector skins. See
page 26 and Remove the Rear Skin on page
5. Remove the 2 screws that secure the AC line filter to the bracket.
6. Disconnect the 2 harnesses from the 110V AC line filter.
220V AC Line Filter
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lamp. See
40
A/C Selector Switch
A
110V Filter
B
220V Filter
C
Remove the Existing Lamp
Remove the Existing Lamp
on page 28.
Remove the Exhaust Panel Skin on
26.
on page 28.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)