Removing The Ac Line Filters; 110V Ac Line Filter - Christie CP2208 Service Manual

Removing the AC line filters

The AC line filters and A/C selector switch are located at the rear-left corner of the projector.
• The 110V filter is for the optional UPS hookup. Use the UPS to keep the projector's electronics
powered ON in the event of a power loss so that the lamp can be struck as soon as full power is
reapplied without having to wait for the electronics to restart.
• The 220V filter is required to power the LPS and strike the lamp.
• The A/C selector switch is used to select between the 110V and 220V power source.

110V AC line filter

1. Turn the projector off and then disconnect it from AC power.
2. Remove the lamp. See
3. Remove the side and rear projector skins. See
and Removing the rear skin
4. Remove the two screws that secure the AC line filter to the bracket.
5. Disconnect the two harnesses from the 110V AC line filter.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
A/C selector switch
A
110V filter
B
220V filter
C
Removing the existing lamp
.
on page 37
Parts and Module Replacement
on page 40.
Removing the exhaust panel skin
A
B
C
on page 39
53