Remove And Replace The Ac Line Filter - Christie J series 2.0kW Service Manual

Section 4: Parts and Module Replacement

4.5.10 Remove and Replace the AC Line Filter

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
2. For the 3.0kW:
a. Remove the locking pin from the bracket surrounding the AC receptacle at the AC inlet.
b. Remove the 2 screws from the AC inlet bracket.
3. For 2.0kW and 2.4kW:
a. Remove the power cord retaining clip.
4. For 3.0kW, disconnect the two inlet connectors and the 2 outlet connectors from the AC line filter
5. Remove the rear cover:
a. Loosen the 8 quick-release screws on the rear cover.
b. Move the cover away from the rear of the projector to access the keypad PCB.
c. Disconnect the projector keypad harness connector P65.
d. Remove the rear cover and set it aside.
6. Remove the 8 screws from the AC cover panel.
7. Pull the left side of the AC cover panel towards you while you slide the right side and pull it forward to
access the AC power switch.
8. For 2.0kW and 2.4kW:
4-16 J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)