Checking The Functions Of The Operation Panel - Fujitsu SPARC M12-1 Installation Manual

2.11 Checking the Functions of the
Operation Panel
This section describes the functions of the operation panel mounted on the SPARC
M12-1.
You can check system operation with the system display (LEDs) and operation
functions on the operation panel.
Figure 2-19
and switches on the operation panel.
For details on system operations not covered in the functional outline of
see "2.3 Confirming the Functions of the Operation Panel" in the Fujitsu SPARC
M12-1 Service Manual.
Figure 2-19 SPARC M12-1 Operation Panel
Table 2-12 LEDs and Switches on the Operation Panel
No.
1
2
3
4
5
36 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
shows the SPARC M12-1 operation panel, and
LED/Switch Functional Outline
POWER LED Indicates the operating status of the system.
On: The system is running.
Off: The system is stopped.
Blinking: The system is being stopped.
XSCF STANDBY LED Indicates the XSCF status of the system.
On: The XSCF is running.
Off: The XSCF is stopped.
Blinking: The XSCF is being started.
CHECK LED Indicates whether the SPARC M12-1 is in an abnormal
state.
Off: Normal state, or no power being supplied
On: Hardware has detected an error.
Mode switch Sets the system operation mode.
POWER switch Starts/Stops the system.
Table 2-12
(1) (2) (3) (4)
shows the LEDs
Table 2-12,
(5)