Mazda RX-8 Workshop Manual page 3778

< Previous Next >
2011 - RX-8 - Body and Accessories
FRONT DRAIN HOSE INSTALLATION
CAUTION:
If the front drain hose is pinched or bent at any point, the water in the hose may not drain
and could leak inside the vehicle.During and after installation of the trims and headliner,
always make sure there is no interference with the front drain hose.Correct any
abnormality if found.
1. Apply soapy water to the part of the sunroof frame where the front drain hose is inserted.
2. Insert the front drain hose end into the sunroof frame.
3. Install the front drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the front drain hose grommet into the hole of the inner hinge pillar.
5. Install the following parts:
a. Headliner (See
b. Assist handle (See
c. Sunvisor (See
d. Interior light (See
e. Map light (See
f. Rear pillar trim (See
g. Tire house trim (See
h. Inner scuff plate (See
i. Rear seat (See
j. A-pillar trim (See
k. Roof side trim (See
< Previous Next >
HEADLINER REMOVAL/INSTALLATION.)
ASSIST HANDLE
SUNVISOR REMOVAL/INSTALLATION.)
INTERIOR LIGHT
MAP LIGHT REMOVAL/INSTALLATION.)
REAR PILLAR TRIM
TIRE HOUSE TRIM
INNER SCUFF PLATE
REAR SEAT REMOVAL/INSTALLATION.)
A-PILLAR TRIM REMOVAL/INSTALLATION.)
ROOF SIDE TRIM
© 2010 Mazda North American Operations, U.S.A.
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
Back to Top