Mazda RX-8 Workshop Manual page 3838

< Previous Next >
2011 - RX-8 - Body and Accessories
HEADLINER REMOVAL/INSTALLATION
1. Remove the following parts:
a. Weatherstrip (See
b. Roof side trim (See
c. A-pillar trim (See
d. Rear seat (See
e. Inner scuff plate (See
f. Tire house trim (See
g. Rear pillar trim (See
h. Map light (See
i. Interior light (See
j. Sunvisor (See SUNVISOR
k. Assist handle (See
2. Disconnect the roof wiring harness connector and remove the roof wiring harness connector clip from the body.
3. Remove the fasteners.
4. Detach the tab from the roof panel and remove the headliner.
5. Take the headliner out from the opened passenger-side door.
6. Install in the reverse order of removal.
< Previous Next >
GLASS PANEL REMOVAL/INSTALLATION.)
ROOF SIDE TRIM REMOVAL/INSTALLATION.)
A-PILLAR TRIM REMOVAL/INSTALLATION.)
REAR SEAT REMOVAL/INSTALLATION.)
INNER SCUFF PLATE
TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
REAR PILLAR TRIM REMOVAL/INSTALLATION.)
MAP LIGHT REMOVAL/INSTALLATION.)
INTERIOR LIGHT REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
ASSIST HANDLE REMOVAL/INSTALLATION.)
© 2010 Mazda North American Operations, U.S.A.
REMOVAL/INSTALLATION.)
Back to Top