Mazda RX-8 Workshop Manual page 3821

< Previous Next >
2011 - RX-8 - Body and Accessories
DASHBOARD REMOVAL/INSTALLATION
1. Disconnect the negative battery cable and wait the one minute.
2. Remove the following parts:
a. Console (See
b. Glove compartment (See
c. Inner scuff plate (See
d. Front side trim (See
e. Side panels (See
f. Hood release lever (See
g. Lower panel (See
h. Knee bolster (See
i. Column cover (See
j. Center panel unit (See
k. Steering shaft installation nuts (See
l. A-pillar trim (See
m. TCM (AT) (See
n. A/C amplifier (See
AMPLIFIER REMOVAL/INSTALLATION [MANUAL AIR
o. Auto light/wiper control module (See
p. Door lock timer unit (See
KEYLESS ENTRY AND START
3. Remove the nuts.
CONSOLE REMOVAL/INSTALLATION.)
GLOVE COMPARTMENT
INNER SCUFF PLATE
FRONT SIDE TRIM
SIDE PANEL REMOVAL/INSTALLATION.)
HOOD LATCH AND RELEASE LEVER
LOWER PANEL REMOVAL/INSTALLATION.)
KNEE BOLSTER REMOVAL/INSTALLATION.)
COLUMN COVER REMOVAL/INSTALLATION.)
CENTER PANEL UNIT
STEERING WHEEL AND COLUMN
A-PILLAR TRIM REMOVAL/INSTALLATION.)
TCM REMOVAL/INSTALLATION
A/C AMPLIFIER REMOVAL/INSTALLATION [FULL-AUTO AIR
AUTO LIGHT/WIPER CONTROL MODULE
DOOR LOCK CONTROL MODULE REMOVAL/INSTALLATION [WITH ADVANCED
SYSTEM].)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
[SJ6A-EL].)
CONDITIONER].)
REMOVAL/INSTALLATION.)
CONDITIONER].) (See
REMOVAL/INSTALLATION.)
A/C