Mazda RX-8 Workshop Manual page 3654

CAUTION:
The engine cannot be started if any step or procedure is skipped. Perform all procedures in the order of the steps.
Conditions
Have two or more valid keys.
NOTE:
If a key ID number cannot be programmed and DTC 15 is displayed, the maximum number of programmed keys may have been
reached. Verify the number of programmed keys using the M-MDS.
If eight keys have already been programmed and it is necessary to program other keys, the previously programmed key ID
numbers must first be cleared.
If "Customer spare key programming disable" is selected, perform additional key programming using the M-MDS. (See
Additional Key Programming Procedure (Using the
Procedure
Step
START ENGINE
1
Start the engine using key 1.
Verify that the security light illuminates for approx. 3 s, and then turns off.
Turn the ignition switch to the LOCK position.
LAUNCH PROGRAMMING MODE
2
Turn the ignition switch to the ON position using key 1.
After verifying that the security light illuminates for approx. 3 s and turns off, turn the ignition switch to
the LOCK position within approx. 4 s using key 1.
Remove key 1.
Turn the ignition switch to the ON position using key 2.
After verifying that the security light illuminates for approx. 3 s and turns off, turn the ignition switch to
the LOCK position within approx. 4 s using key 2.
Remove key 2.
M-MDS).)
Procedure
No. 2
Action after
procedure
Go to the next
step.
Go to the next
step.