Mazda RX-8 Workshop Manual page 3650

Verify that the keyless warning light illuminates for
approx. 3 s, and then turns off.
After vehicle identification, select the following from the M-
MDS initial screen.
Perform the security access according to the directions on
the M-MDS screen.
Select the replaced parts according to the directions on the
M-MDS screen.
Verify that the PATS function menu is displayed again on
the M-MDS screen.
CLEAR IGNITION KEY ID NUMBERS
4
Select "Ignition Key Code Erase and Program" from the M-
MDS screen menu.
Clear the ignition key ID number according to the
directions on the M-MDS.
PERFORM IGNITION KEY ID NUMBER PROGRAMMING
5
Program two keys according to the directions on the M-
MDS.
Using an IDS (laptop PC):
Select the "Body"
Select the "Security"
Select the "PATS
function"
Select the "Parameter
Reset"
Using a PDS (pocket PC):
Select the "All Tests and
Calibrations"
Select the "PATS
Functions"
Select the "Parameter
Reset"
If the keyless control module is replaced:
Select "RKE".
If the PCM is replaced: Select "PCM".
CAUTION:
At this time, do not
select the other parts
from the M-MDS menu.
Go to the next step.
Go to the next step.