Mazda RX-8 Workshop Manual page 3660

CLEAR IGNITION KEY ID NUMBERS
2
Connect the M-MDS to the DLC-2.
(See M-MDS Connecting
Turn the ignition switch to the ON position using key 1.
NOTE:
Although the security light starts flashing and DTC 15 is displayed after approx.
1 min, this does not indicate an improper procedure. Continue to perform the
procedure as indicated.
After vehicle identification, select the following from the M-MDS initial screen.
Using an IDS (laptop PC):
Using a PDS (pocket PC):
Perform the security access according to the directions on the M-MDS screen.
PERFORM IGNITION KEY ID NUMBER PROGRAMMING
3
Program two keys according to the directions on the M-MDS.
Verify that the PATS function menu is displayed again on the M-MDS screen.
PERFORM Steering Lock Unit Programming
4
Select "Steering Lock Unit Programming" from the M-MDS screen menu.
Complete the Steering Lock Unit Programming according to the directions on the M-MDS.
(See STEERING LOCK UNIT ID CODE REGISTRATION [WITH ADVANCED KEYLESS ENTRY AND
START SYSTEM].)
After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish
(this menu)".
Turn the ignition switch to the LOCK position.
Disconnect the M-MDS from the DLC-2.
Remove the programmed card key from the vehicle.
VERIFY KEY 1 PROGRAMMING PERFORMED CORRECTLY
5
Start the engine using key 1.
Verify that the security light and keyless warning light operate as shown in the following figure.
Turn the ignition switch to the LOCK position and remove key 1.
Procedure.)
Select the "Body"
Select the "Security"
Select the "PATS function"
"Ignition Key Code Erase and Program"
Select the "All Tests and Calibrations"
Select the "PATS Functions"
"Ignition Key Code Erase and Program"
Go to the next step.
Go to the next step.
Go to the next step.
Go to the next step.