Mazda RX-8 Workshop Manual page 3781

< Previous Next >
2011 - RX-8 - Body and Accessories
REAR DRAIN HOSE INSTALLATION
CAUTION:
If the rear drain hose is pinched or bent at any point, the water in the hose may not drain
and could leak inside the vehicle.During and after installation of the trims and headliner,
always make sure there is no interference with the rear drain hose.Correct any abnormality
if found.
1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:
a. Trunk side trim (See
b. Trunk end trim (See
c. Headliner (See
d. Assist handle (See
e. Sunvisor (See
f. Interior light (See
g. Map light (See
h. Rear pillar trim (See
i. Tire house trim (See
j. Inner scuff plate (See
k. Rear seat (See
l. A-pillar trim (See
m. Roof side trim (See
< Previous Next >
TRUNK SIDE TRIM
TRUNK END TRIM
HEADLINER REMOVAL/INSTALLATION.)
ASSIST HANDLE
SUNVISOR REMOVAL/INSTALLATION.)
INTERIOR LIGHT
MAP LIGHT REMOVAL/INSTALLATION.)
REAR PILLAR TRIM
TIRE HOUSE TRIM
INNER SCUFF PLATE
REAR SEAT REMOVAL/INSTALLATION.)
A-PILLAR TRIM REMOVAL/INSTALLATION.)
ROOF SIDE TRIM
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)