Mazda RX-8 Workshop Manual page 3866

< Previous Next >
2011 - RX-8 - Body and Accessories
REAR PILLAR TRIM REMOVAL/INSTALLATION
1. Remove the rear seat. (See
2. Remove the inner scuff plate. (See
3. Remove the tire house trim. (See
4. Remove the cap using a fastener remover.(Vehicles with curtain air bags)
5. Remove the bolt. (Vehicles with curtain air bags)
6. Remove the fastener.
7. Detach clips A and locator pin B, using a fastener remover, and remove the rear pillar trim.
8. Install in the reverse order of removal.
< Previous Next >
REAR SEAT REMOVAL/INSTALLATION.)
INNER SCUFF PLATE
TIRE HOUSE TRIM
© 2010 Mazda North American Operations, U.S.A.
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
Back to Top