Mazda RX-8 Workshop Manual page 3845

< Previous Next >
2011 - RX-8 - Body and Accessories
FRONT DOOR TRIM REMOVAL/INSTALLATION
CAUTION:
If the pad installed to the inside of the front door trim is damaged it could cause looseness
resulting in the occurrence of abnormal noise. Be careful when handling the front door trim
so that it does not receive an impact by being hit or dropped.
1. Disconnect the negative battery cable.
2. Using a small flathead screwdriver, open the cap and remove the screw, then remove the
inner handle cover.
3. Remove the inner garnish. (See
4. Using a flathead screwdriver, pry up the rear part of the switch panel and detach the clip.
INNER GARNISH REMOVAL/INSTALLATION.)