Mazda RX-8 Workshop Manual page 3700

< Previous Next >
2011 - RX-8 - Body and Accessories
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION
1. When replacing the keyless control module, perform the following procedure:
Keyless Control Module Configuration
(See
Immobilizer System-related Parts Programming[with advanced keyless system]
(See
ADVANCED KEYLESS ENTRY AND START
Immobilizer system-related parts programming[with keyless entry system]
(See
ENTRY
2. Disconnect the negative battery cable.
3. Remove the front side trim. (See
4. Remove the nut and screw.
5. Remove the connector clip installed to the bracket by shifting the keyless control module
KEYLESS CONTROL MODULE
.IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH
IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH KEYLESS
SYSTEM].)
FRONT SIDE TRIM
CONFIGURATION.)
SYSTEM])
REMOVAL/INSTALLATION.)