Logic Analyzer Pod 6 - Intel 80331 Design Manual

Intel® 80331 I/O Processor Design Guide
Debug Connectors and Logic Analyzer Connectivity
Table 83.

Logic Analyzer Pod 6

Mictor-38 Pin Number Even Pod
The recommended placement of the mictor connectors is at either end of the bus segment. The
mictors are placed at the end of, as short a stub as possible, daisy chained off either end of the bus.
When there is not enough room to place the mictors 0.5 inches from the target, then an alternate
method may be used. That is, to place the logic analyzer termination circuitry on the target and then
extend the etch from the end of the termination circuitry over to the mictor connectors. The
connection from the mictors to the logic analyzer must then be done with the E5351A. The
E5346A contains the logic analyzer termination circuitry, the E5351A does not.
146
Logic Analyzer Channel Number
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
CLK/16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
PCI-X Signal Name
Unused
AD63
AD62
AD60
AD59
AD58
AD57
AD56
AD55
AD54
AD53
AD52
AD51
AD50
AD49
AD48
AD48