Limiting Bsr Message To Advertise To Candi; Date-Rp; Setting Dr Priority; Configuring Interval To Send Hello Message - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv6 Volume)
Command
ipv6 router pimsm accept-rp
ZXR10(config)#
<access-name>
Command
ZXR10(config-if-vlanX)#
Command
ZXR10(config-if-vlanX)#
<seconds>
68 Confidential and Proprietary Information of ZTE CORPORATION
Limiting BSR Message to Advertise
to Candidate-RP

Setting DR Priority

ipv6 pim dr-priority <priority>
It is necessary to select a DR in a shared (or Multi-Access) network
segment. Router with the highest priority will win the selection. If
the priorities are similar, the router with the greatest IP address
will be selected.
In the shared network segment connected with the multicast data
source only the DR can send the registration information to the RP.
In the shared network segment connected with the receiver only
the DR can respond to the joining and leaving messages of the
MLD and sends the PIM joining/prune message to the upstream.
The priority of the router is contained in the exchanging Hello mes-
sage with the neighbor. The default value is 0.
Configuring Interval to Send Hello
Message
ipv6 pim hello-interval
The interval to send hello message can be configured according to
network conditions. It is 30 seconds by default.
Function
This limits BSR message to
advertise to Candidate-RP.
Function
This sets DR priority.
Function
This configures interval to send
Hello message.