Smbhstdat1-Smbus Host Data 1 Register (I/O); Smbblkdat-Smbus Block Data Register (I/O); Smbslvcnt-Smbus Slave Control Register (I/O) - Intel 460GX Software Developer’s Manual

SM Bus Controller Configuration
14.3.7 smbhstdat1–SMBus Host Data 1 Register (I/O)
I/O Address:
Default Value:
Attribute:
This register is transmitted by the SMBus controller host interface in the Data1 field of the SMBus
protocol.
Bit
7:0
14.3.8 smbblkdat–SMBus Block Data Register (I/O)
I/O Address:
Default Value:
Attribute:
Reads and writes to this register are used to access the 32 byte block data storage array. An internal
index pointer is used to address the array. It is reset to 0 by reading the SMBHSTCNT register. The
index pointer then increments automatically upon each access to this register. The transfer of block
data into (read) or out of (write) this storage array during an SMBus transaction always starts at
index address 0.
Bit
7:0
14.3.9 smbslvcnt–SMBus Slave Control Register (I/O)
I/O Address:
Default Value:
Attribute:
The control register is used to enable SMBus controller slave interface Functions.
Bit
7
6:3
2
1
14-10
Base + (06h)
00h
Read/Write
SMBus Data 1 (SMBD1)–R/W. This register should be programmed with the value to be
transmitted in the Data1 field of an SMBus host interface transaction.
Base + (07h)
00h
Read/Write
SMBus Block Data (BLK_DAT)–R/W. This register is used to transfer data into or out of the
block data storage array.
Base + (08h)
00h
Read/Write
SLV_INT_EN: When set to a '1', the generation of a slave interrupt or SMI# based on a master
SMB device generating an access to the host controller's slave port is enabled. The slave port
will set the SLV_STS bit in the Slave Status register (offset 01h). The data will placed in the
Slave Data register (offset 0Ah).
Reserved.
SMBus Shadow Port 2 Enable(SHDW2_EN)–R/W. SLV_INT_EN and SHDW2_EN =1 will
enable the generation of an interrupt or resume event upon an external SMBus master
generating a transaction with an address that matches the SMBSHDW2 register. 0 = Disable.
SMBus Shadow Port 1 Enable(SHDW1_EN)–R/W. SLV_INT_EN and SHDW1_EN =1 will
enable the generation of an interrupt or resume event upon an external SMBus master
generating a transaction with an address that matches the SMBSHDW1 register. 0 = Disable.
Description
Description
Description
Intel® 460GX Chipset Software Developer's Manual